Side-Power RC-10E Manual do Utilizador descarregar pdf (Página 3)

Installation & User Manual, Radio Remote RC10E Page 3

• YoumustalwaysinstallatleastoneoriginalSide-Powerpanel.

• With the boat on land, only run the thruster for a fraction of a second, as without resistance it

will accelerate very fast to a damaging rpm.

• This manual is intended to support educated / experienced staff and is therefore not sufcient

in all details for the correct installation.

• When installed in boats approved or classied according to international or special national

rules, the installer is responsible for following the demands in accordance with these regula-

tions / classication rules. The instructions in this guide can not be guaranteed to comply with

all different regulations / classication rules.

• The transmitter and the receiver have the same factory preset code so no programming is nec-

essary. When additional transmitters are to be used, the receiver must be programmed again

for all transmitters (please see programming section on page 7).

• If a Side-Power automatic main switch is tted, the “OFF” button on your transmitter will shut

off the main switch providing no other control panels are “ON”.

Transmitter Receiver

Model RCT-10E RCR-1E

Power feed 1 x 3V battery (type: CR2032) From thruster

Frequency (MHz) 433,2 433,2

Operation temp. -10°C / +55°C -15°C / +55°C

HxWxD (mm) 95x48x25 89x68x33

Weight (g) 60 135

Voltage: 8-30V

Load, max 4A

Operating range: 15m under normal operating conditions

Technicalspecications

Important precautions

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Side-Power RC-10E Manual do Utilizador Página 3