G
B
C
D
F
A
H
A
B
C
E
G
F
E
B
A
H
F
D
THE STERN-THRUSTER MUST BE KEPT DRY AT ALL TIMES
Description of illustrations:
A : All draining holes or other open-
ings from wet areas into the
thruster installation compartment
must be sealed.
B: Originally non-sealed bulkhead
C: Stringers in the boats lenght
directions, normally there are
drain holes through these
from side-compartments
D: Plate above bilge where the
steering system and other
technical installations are often
installed
E: Watertight bulkhead to engine room.
F: Thruster
G: Ensure there are draining holes in these
positions to lead the water to the bilge to
be pumpe out.
H Make anti drip edges on all surfaces
above the thruster compartent to
ensure that any water here will go via
the drain holes and to the wet part of
the bilge.
Stern thruster installation manual Version 1.6 - 2005
6
SPECIAL INSTALLATION INSTRUCTIONS
Sidepower SP 55 Si
As the motorbracket are completely inside the stern-tunnel, the oil-pipe must be changed to an elbow
connection so that the oil hose will not be bent, preventing from constrictions.
1. Remove the straight hose pipe in the bracket.
2. Install the elbow hose pipe connection that came with the stern-tunnel, be sure to use a sealant on the
threads, but not so much that it closes the oil feed into the bracket.
S
idepower SP75Ti / SP95Ti / SP125Ti / SP100HYD
As there are no room to place and fasten the lower part of the flexible coupling after the electric motor is
fastened on the bracket, this must be done before fitting the motor.
PS! The part of the flexible coupling that is fastened on the
motor, is prefixed in a specific position, on which this procedure
is based. DO NOT MOVE IT !
1. When the gearhouse and bracket are mounted on the stern-
tunnel, place the lower part of the coupling on the
driveshaft.
2. Adjust the height of the lower part of the coupling to the
measurement given in FIG. 8
3. Apply a thread glue (Locktite or similar) to the set screws
and fasten the coupling by tightening both setscrews.
Sidepower SP155TCi / SP200TCi / SP240TCi /
SP285TCi / SP220HYD / SP300HYD
The lower part of the flexible coupling does not have to
be tightened to the driveshaft. The fastening on the
motor is sufficient. PS! Make sure the key on the shaft
is in its correct position when sliding the motor with the
flexible coupling onto it (see FIG. 9).
FIG. 8
FIG. 9
Stern thruster installation manual Version 1.6 - 2005
7
Version 1.7.1 - 2010
Side-Power SH100/SH160 & older SP75/SP95/SP125 models
Side-Power SE210/SE240/SE285/SH240/SP300HYD
& older SP155/SP200 models
Side-Power SP55 (old model)
(17 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais